产品详情
1)、使用前应先空升一次,观察各部位是否正常,如有缺陷,应停止使用;交专业维修人员调试。
1) Before use, it should be lifted up once to observe whether the parts are normal or not. If there are defects, it should be stopped. It should be debugged by professional maintenance personnel.
2)、在维修保养和清扫升降平台时,在撑起安全撑杆后进行。
2) When the lifting platform is maintained and cleaned, it is carried out after supporting the safety brace.
3)、当电量显示不足40﹪时,要及时充电。充电时要检查一下电瓶水,若小于20ml,既得加水。
3) When the power consumption is less than 40%, it should be charged in time. When charging, check the battery water. If it is less than 20ml, add water.
4)、电器及液压系统应由专业人员维护保养。
4) Electrical and hydraulic systems should be maintained by professionals.
5)、设备使用约2个月时(根据实际使用频率)需对转动部位加注一次润滑脂;
5) When the equipment is in use for about 2 months (according to the actual frequency of use), it is necessary to add lubricating grease once to the rotating part.
6)、每月定期检查液压升降机销轴工作状态,如发现销轴紧定螺丝松脱,一定要销紧,以防轴销脱落造成事故。
6) Check the working state of the pin shaft of the hydraulic elevator regularly every month. If the pin shaft tightening screw is loose, the pin must be tightened to prevent accidents caused by the pin falling off.
7)、液压油应保持清洁,每6个月更换一次;
7) Hydraulic oil should be kept clean and replaced every 6 months.
8)、在室内、外使用要注意,在室外使用时应在地质坚硬的地面上使用,以免发生颠覆,每使用20次调整一次链条螺丝、调整一次保险绳螺丝,在使用时,不能停在倾斜度大于30°的坡上工作,以防升降机下滑;
8) In indoor and outdoor use, attention should be paid to the use of geological hard ground in outdoor use, in order to avoid subversion, every 20 times used to adjust the chain screw, adjust the safety rope screw, when using, can not stop at the slope of more than 30 degrees to work, in order to prevent the lift from sliding;